TREVISAN
MANUFACTURER FULL LINE OF HORIZONTAL U-AXIS MACHINING CENTER

Since 1963 Trevisan has established itself in the world for the technology developed above all at the service of the energy sector. But there is so much more. Our highly customizable machining centers are confirmed to be performing and reliable even in the agricultural, space, aeronautical, naval, automotive, mechanical, oil & gas and renewable energy sectors.

100% MADE IN TREVISAN
Trevisan machine tool carries out most of machining inside the company, in order to control, step by step, the manufacturing of the components for the machines.
Trevisan machine tool has traditional and CNC machines for its own production processes, including CNC grinders.

DUAL SPINDLE DESIGN

Trevisan’s horizontal machining center has a unique head design that houses two seperate spindles; one for the spindle quill, and the other for a U axis facing head. With the combination of milling and turning, this spindle head can complete the entire machining process with one set up.

HEAVY DUTY SPINDLE QUILL

Trevisan’s second spindle supports a quill for milling, drilling, and tapping. This large, heavy duty spindle can handle the toughest milling operations for quick metal removal rates.

HEAVY DUTY SPINLE QUILL

The Trevisan Ram series has large diameter extendable “W” axis quill to allow a more rigid reach to your parts.

The NEW DS600/200c ram has 2 separate 100HP direct drive spindle motors, One for the quill and one for the contour head.

STATIONARY PART MACHINING

By holding the part stationary and moving the machine around the part, Trevisan can machine a wider variety of parts. Large parts can be turned without rotating the parts.

This allows optimum cutting speeds over rotating large parts.  With the multi-pallet set up, fully programmable  B axis table, the machines can process many parts from start to finish in just one setup. Part changeover is done while machine is in operation reducing or eliminating changeover time This combined with the dual spindle design can significantly reduce cycle time, which in turn increases production and profit.

INTEGRATED U AXIS FACING HEAD
By integrating a facing head on a separate spindle in combination with a separate quill, it creates a whole new dimension to the machining center, giving you all the pros of a lathe machine without the cons.

OFF-CENTER & UNBALANCED TURNING
By using a facing head on a horizontal machining center, the machine can turn or bore offset diameters at any location on the part without the unbalanced condition as you would with traditional turning.

To turn with a machine with a just a milling head, you must either use complicated ways to manipulate the machine and head to turn the part causing wear and tear on the machine that isn’t needed or buy a third party facing head.

 The integrated facing head allows Trevisan to machine items such as Fluid ends, Valves, Pump housing, Gearboxes, Axle housings and other parts with off center turning work much more efficiently than other processes.

Products

MACHINING CENTERS

SPECIAL MACHINES